If you have a reasonable grasp of DIY it is not as difficult as you imagine to build your own narrow boat from a kit of parts.
The
components used in the Little Brown Mouse Kits are exactly the same as the ones we use in our own constructions and are designed to
fit the Jonathan Wilson/Mike Christian Hull.
Each component pack comes with full instructions and site support should you need
it. You can purchase each pack as you are ready.
Mike Christian Classic Semi Trad Hull 55ft fitted with:
Fully painted hull in single primary colour and Comastic below waterline.
Side
hatch and hardwood front doors.
Ballast and 18mm W.B.P. ply flooring.
Vetus 4.17 Mitsibushi engine.
Twin alternator and delux panel.
Greasless
stren gear and Vetus prop.
6 x Channel Glaze 36" 'S' plan windows and two 12" portholes.
5 x Brass mushroom vents.
6 x Brass fender eyes.
130
Gallon water tank.
Thinsulate and adhesive.
Full set of upper panels in Oak.
Full set of lower panels in Oak.
Bearers for panels and services.
Bulkhead formers
and sheathing ply.
Ceiling ply and hardwood trims.
2 x Doors in Oak veneer.
Fastening pack.
Full wiring harness ready to fit.
1500 Watt full sinewave Powermaster inverter.
4 x 110Ah leisure batteries.
Powerline auto changeover
panel.
Vetus domestic water pressure set.
Whale shower pump.
D.E.P. high recovery calorifer.
'S' plan, 'Corridor' or 'L' plan kitchen complete with Spinflo Caprice cooker,
Whrlpool fridge/freezer and solid Acrylic worksurfaces
Pullman Dinette (less upholstery) with under seat drawers.
Extending double bed with storage under
Front steps with drawer storage
Rear steps with drawer storage
Bathroom Vanitory unit with inset or raised sink
Other furniture available on request
Engineering and Electrical Pack
Furniture; Completely Assembled Ready To Screw Into Position